Tips & Tricks

Some tips and tricks to get the best out of your ecig and vaping experience.

When Vaping : 
To get the best out of your inhale it is always best to emply the "primer puff" - This is a short half second or so, inhale or exhale on the Ecig, to pre heat the atomiser before you take a deeper drag.

Your inhale should be longer and slower than normal analogue smoking. this will generate a warmer thicker vapour than just sucking and hoping for the best.

Should the LED on the ecig go out when still inhaling , simply check that the cart / atomiser is not too dry or too hot. ( this occurs when heavy vaping.) If its too dry then either wait for the wool to catch up or top up the cart. If Too hot allow the atty to cool for a few minutes.

Always carry a spare battery(s) with you - sods law dictates your other one will run out of charge when out.

Somtimes you may want a heavier pull on the Ecig. You can simply achieve this by covering a couple of the "breather" holes  located at the joint between the atomiser and battery with your fingers when holding the electronic cigarette.

Storage and Care :
The battery 'microphone' switches are initially very sensitive before they "break in". It is always prudent to disengage from the atomiser when not in use. ( Half a turn usually works or full disassemble and use a case.) more so when in noisy / windy environments.

The first charge of your battery should ideally be between 7 - 8 hours. (even thought the charger light will go green) Then normal charging is fine.

Dont allow E-liquid / Fluids to get into the battery . It will /may severely damage the microphone switch.

If left for long periods disassemble the ecig and try to store your atomiser vertically pointing up with a blank cart attached to catch any e-liquid that will drain down.

Cleaning & Maintainence.:
Always keep the connectors between atomiser and battery clean -Dirty joints can really affect your Ecig performance.
Use a damp "Q-TIP /Cotton Bud " for the battery end. and Kitchen towel/ cloth for the atomiser connector.
Avoid turning the center connectors as it may result in snapping the wires .

Cartridges : to improve the tightness of the fit into the atomiser - Squeeze  the flattened edge of the cart together. this will improve the seal and fit should you require it.

There are many methods of cleaning your atomiser.( see vaping/ ecig forums) The carbon like build up on/ over the element eventually leads to several aspects of atomiser death. either by snapping the joints or killing the element due to very high resistance.

Allowing your atomiser to soak in a glass of cola overnight , rinsing it out in water ,then drying & blowing it out thoroughly, has been reported to work well when employed on a regular basis ( every 5-7 days). Remember to re-prime the atomiser with a few drops of e-liquid before use.

Please Note : All Atomisers will eventually stop working.